「NINA SHAH DR. Doctor of Medicine」は FontVibe AI で作成したレーザーカットの文字エフェクトです。暖かな白樺材から切り出した太いサンセリフ大文字。焦げたカット面と木目が見え、暗いウォルナットの板から浮き上がり、琥珀色の横光。

A finished laser-cut office name plaque, photographed as a flat-lay on a dark raw walnut-timber workshop surface. The main lettering reads "NINA SHAH" in one line of bold stencil display capitals with uniform heavy stroke weight, angular shear-cut terminals and structural bridge gaps. The letters fill about 78% of the frame width, centered slightly above the middle. Each letter is a separate slab of thick 10mm warm honey birch plywood with visible fine grain on its face. A dark charred seam borders every cut edge, and the cross-grain cut face is visible on the sides. The A and H are held together by thin stencil bridges whose gaps read as dark slots, with the bridge tabs clearly shown. Beneath the name, in a much smaller line, is "DR." is not used here; instead the line reads "Doctor of Medicine" in small, evenly spaced stencil capitals, cut from the same birch at about 30% of the name's width and centered. Above the name, a small line "DR." cut in the same stencil style, about 10% of frame width, centered. The lines are "DR." on top, "NINA SHAH" in the middle and "Doctor of Medicine" below, with a vertical spacing ratio of about 1:5:1.5. Warm amber light rakes from low-left at a shallow angle, laying fine sharp shadow lines along every kerf edge and showing the slab depth as a shadow face on the right side of each letter. The dark timber background carries subtle warm grain and falls to near-black at the edges. Nothing else is in the frame: only the cut letters, the surface and the light. No glow, no outlines and no drop shadows beyond the physical slab shadows.